IMPORTANT NOTES
- If you are updating from a version older than 1.4.1, you MUST update to 1.4.1 FIRST. Then you can update to 2.0.7. The 1.4.1 update is included in the 2.0.7 download link below.
- If you are updating from a version older than 2.0.7, you MUST update to 2.0.7 FIRST. Then you MUST contact JPS Support BEFORE updating to the latest version.
- If you are updating from a version older than 2.2.2, you MUST contact JPS Support BEFORE updating to the latest version.
- If you are updating from a version older than 3.1.1, you MUST update to 3.1.6 BEFORE you update to version 4.1.0.
Version - 4.1.0 (Update from 4.0.0) OR (Update from 3.1.X)
Version - 3.1.6
Version - 2.0.7 (also contains 1.4.1 secure update file)
Instructions
- Browse and log in to the RSP-Z2
- Select the three lines on the top right of the page and click the 'Upload New Firmware' button
- Choose the file downloaded above and click 'Update'.
- Optional: Select 'Clean Install' to factory reset (IP address and user logins persist) the device simultaneously. This does not work for the initial upgrade to v4.1.0.
- Allow the firmware update to finish and the RSP-Z2 to reboot. The update process can take several minutes. Do not power off the RSP-Z2 until the update process has completed and the fault light ceases blinking.
- During the initial upgrade to v4.1.0, after the fault light ceases blinking, you will need to manually refresh the browser page a couple times to access the UI again. "Waiting for Reboot" will not automatically refresh the login page. You may need to clear the browser cache and login to the IP address again.
Additional Information
- All v3 and earlier firmware comes as a .tgz file, as well as the initial v4 firmware migration file. Future v4 updates (updating from 4.0.0 and beyond) will be .jps files.
- There are many changes included with the update to the v4 firmware, please see the updated documentation.
- Release notes available here.